The Hiram Percy Maxim Memorial Station, W1AW, and WA6ZTY on the West Coast will conduct a summer Frequency Measuring Test (FMT) on July 1 at 9:45 PM EDT (0145 UTC on July 2). MARCA will participate as a club event. Norm (aa7oo) will host this event at his shack. Dusty (w7itm) will be the technical lead and guide us through the process. The results will be submitted to ARRL as a club entry. See callendar for details.
According to FMT Coordinator H. Ward Silver, N0AX, the format will be a "do-over" of the dual-tone test conducted in November of 2008: "The timing glitches that occurred during the November test have been ironed out, so the format will be repeated to give everyone another opportunity to make measurements."
Silver said that both stations will transmit on a carrier frequency of 3597.5 and 7095 kHz; these are the W1AW digital bulletin frequencies. Two audio tones between 2000 and 2500 Hz will be transmitted in an alternating sequence, with a shift between 100 and 500 Hz. This is similar to what is used for RTTY communication. Beginning on 80 meters, Tone 1 will be transmitted for 10 seconds, followed by Tone 2 for 10 seconds. The tones will then alternate until each tone has been transmitted six times, for a total transmission of 120 seconds. The transmitting station will then change to 40 meters -- after identifying in Morse code -- and repeat the two-tone sequence.
All transmissions for announcing the test, identification and band changes will be in CW at 15 WPM (18 WPM character speed). CW transmissions will be on the carrier frequency, with each lasting more than one minute.
According to Silver, the FMT has been run in the past where a modulated carrier or audio tones are held steady for a very long time. "This 'classic' carrier frequency FMT format will return in November," he said. "The new format addresses the growing important of digital modes. The challenge of this format is to make quick, accurate measurements of the characteristics of a digital signal where the tones do not stay steady for a long period of time. It's not expected that the level of accuracy demonstrated for a long-tone test will be achieved for these short tone transmissions -- that's not the point."
Silver said that he predicts there will be a future FMT that will conduct a true-FSK test. "In this future test, there would be four variables: Carrier frequency, Audio Tone 1, Audio Tone 2 and Shift," he said. "Given the value of any one of the variables in advance, two of the remaining variables would be measured and the final variable calculated or measured. The symbol rate (the number of transitions per second) would be representative of actual digital signals. For example, a 60 WPM RTTY signal."
Silver said that this can present some challenges to FMT participants: "One of the reasons we conduct the FMTs goes back to FCC Part 97.1 (c): '...advancing skills in both the communication and technical phases of the [radio] art.' We look forward to seeing the creativity and innovation of the measurement community applied to this new format."
Attention: we notice that you are using an older browser. We no longer support this version of your browser. Please install one of the supported browsers listed below
Continuing may result in unexpected behavior